Difference Between Tundish Metering Nozzle and Quick Exchange Tundish Nozzle
Oct 24, 2026
In continuous casting for steel production, both tundish metering nozzle and quick exchange tundish nozzle control molten steel flow from tundish to mould, but they differ in core design, operation logic and applicable casting scenarios.
Tundish Metering Nozzle
The metering nozzle relies on a fixed zirconia bore to set flow rate. Flow is mainly determined by the inner diameter, tundish liquid level and steel temperature. It is normally fixed assembled; once worn, blocked or enlarged by molten steel erosion, casting has to stop for replacement.
- Core feature: Fixed bore, fixed installation, stable flow under steady tundish level
- Operation: No online exchange during casting
- Advantage: Simple structure, low initial cost, stable stream for normal billet casting
- Limitation: Nozzle service life restricts tundish sequence time. Bore enlargement will change flow and casting speed
- Typical use: Long sequence casting with stable steel grade, small billet continuous casting, low-to-medium carbon steel
Quick Exchange Tundish Nozzle
Quick exchange tundish nozzle is a modular assembly, including fixed upper nozzle and replaceable lower metering nozzle. It matches a mechanical or hydraulic changer system. Operators can swap the worn lower nozzle online without emptying the tundish or stopping casting.
- Core feature: Split modular structure, quick-lock mechanism, online hot change
- Operation: Replace lower nozzle while casting continues
- Advantage: Extend tundish service life greatly, reduce casting interruption, improve yield, support multi-heat continuous casting
- Limitation: Higher system investment, strict requirement on sealing and thermal shock resistance of exchangeable part
- Typical use: High-efficiency continuous casting lines, frequent long-sequence production, occasions where tundish life needs decoupled from nozzle life
Side-by-Side Comparison
| Item | Tundish Metering Nozzle | Quick Exchange Tundish Nozzle |
|---|---|---|
| Structure | Integrated fixed nozzle | Split: fixed upper nozzle + exchangeable lower nozzle |
| Replacement mode | Stop casting to change | Online hot change during casting |
| Flow control | Fixed bore | Fixed bore (metering function) + quick-change function |
| Tundish campaign limit | Limited by nozzle life | Nozzle can be replaced, longer tundish campaign |
| System requirement | Simple installation, no changer mechanism | Need matched quick exchange fixture / hydraulic unit |
| Cost | Lower refractory cost | Higher total system cost |
| Suitable scenario | Stable short sequence, simple caster | High output, long continuous casting |
A tundish metering nozzle is a flow-control component by fixed bore. Quick exchange tundish nozzle is a metering nozzle built into a quick-change system. Many quick exchange nozzles still use zirconia metering inserts, so metering function is retained. The biggest difference is whether online replacement is available without breaking the cast.
Steel mills select according to target tundish life, output schedule and budget. If you pursue long continuous casting time and less downtime, quick exchange type is preferred. If production runs stable short sequences with cost priority, standard metering nozzle works well.
If you need stable casting speed control and fewer shutdowns, our team can provide matched tundish nozzle solutions for your caster. Send your strand size and casting parameter for technical drawing and quotation.






