Zirconia Insert Material & Working Principle
Oct 30, 2026
Zirconia insert is the core wear-resistant lining part of tundish nozzles and submerged entry nozzles for continuous casting. It directly contacts high-speed molten steel and slag, so its material selection decides casting stability and sequence length.
Pure zirconia will crack easily under temperature cycling. Changtai adds stabilizers like yttria, magnesia or calcia to stabilize its crystal structure. After isostatic pressing and high-temperature sintering, the finished insert gains good erosion resistance and thermal shock resistance. It works on the transformation toughening mechanism: when tiny cracks start to form under thermal stress, local crystal phase change brings slight volume expansion, which restrains crack spreading and avoids sudden breakage.
The outer nozzle body normally uses alumina-carbon material. It takes charge of structural support and heat insulation, while the zirconia insert bears the direct scouring of molten steel. This composite structure balances cost and performance, which is widely accepted by steel mills.
| Item | Zirconia Insert (Inner Liner) | Alumina-Carbon Nozzle Body (Outer Layer) |
|---|---|---|
| Main composition | ZrO₂ ≥94% + Y₂O₃ / MgO stabilizer | Al₂O₃ + graphite + antioxidant |
| Core duty | Resist molten steel & slag erosion, control inner bore size | Provide mechanical support, buffer thermal stress |
| Bulk density | ≥5.2 g/cm³ | ≥2.6 g/cm³ |
| Apparent porosity | ≤9% | ≤18% |
| Working feature | High refractoriness, slow erosion rate, keep bore stable | Better thermal shock tolerance, lower raw material cost |
| Common failure risk | Bore enlargement, slag adhesion, thermal cracking | Delamination at bonding surface, oxidation at high temperature |
In actual casting, molten steel flows through the inner channel of zirconia insert. If the insert wears too fast, the bore will become bigger, steel flow rate goes out of control and casting parameters drift. Changtai controls raw material purity, sintering curve and machining tolerance strictly. We adjust stabilizer dosage according to different steel grades and casting conditions, to match your production schedule.
We supply standard zirconia inserts and custom sizes based on drawings. Contact Changtai for technical discussion and sample support.





