Is thermal shock the main failure reason for slide gate plate?

Nov 17, 2026

In continuous casting production, slide gate plates are core functional refractories for ladle and tundish flow control. Many users and engineers have raised the same question: Is thermal shock the main failure reason for slide gate plate? The short answer is: thermal shock is the primary trigger for crack initiation, but not always the final dominant failure cause in full service cycles. Slide gate plate failure comes from coupled thermo-mechanical and thermochemical attack, rather than a single thermal shock factor.

 

When an un-preheated or poorly preheated slide gate plate meets molten steel above 1600°C instantly, a huge temperature gradient creates tensile stress around the casting bore. Radial microcracks develop starting from the hole; this is typical thermal shock damage. If preheating is skipped or rushed, thermal shock can directly lead to plate spalling and bursting at the first heat, which makes thermal shock look like the main failure mode in these accident cases.

 

However, under standard and stable preheating procedures, thermal shock only opens microcracks. These cracks become channels for slag penetration, carbon oxidation and molten steel infiltration. Thermochemical erosion and high-speed steel flow scouring will then expand cracks, enlarge the bore and weaken the sliding surface step by step. This forms a vicious cycle: thermal shock creates cracks → slag and steel penetrate → chemical corrosion accelerates crack propagation → abrasion and spalling finally retire the plate.

 

Field data shows different working conditions shift the leading failure mechanism:

  • Ladle slide gate plates with insufficient preheating: thermal shock cracking is the dominant failure mode
  • Ladle plates with qualified preheating for multi-heat continuous casting: thermochemical corrosion and steel scouring take over as the main failure reason
  • Tundish slide gate plates with standard preheating: thermal shock impact is much milder; sliding surface friction and alumina clogging become more common limiting factors

 

Other secondary factors cannot be ignored either. Mechanical misalignment, uneven clamping pressure, repeated sliding friction, improper storage and installation also shorten plate life. Modern Al₂O₃-C and ZrO₂-Al₂O₃-C slide gate formulas add graphite and zirconia phases to improve thermal shock resistance, but these formulations still face carbon oxidation and slag corrosion limits during long casting sequences.

 

·For steel mills and refractory buyers, the takeaway is clear. Improving thermal shock resistance cannot solve all slide gate plate failures. Reliable service life needs matched solutions: controlled gradual preheating, proper material grade selection against slag chemistry, flatness control of sliding faces, standardized gate maintenance and clamping inspection.

 

Thermal shock acts as the crack initiator. Whether it becomes the main failure cause depends heavily on preheating quality and casting conditions. In normal multi-heat operation, coupled chemical erosion and abrasion are the ultimate reasons for slide gate plate retirement.