What are the main components of quick‑change tundish nozzle assembly
Sep 22, 2026
The quick‑change tundish nozzleassembly is a core refractory unit for continuous casting operations. It allows worn nozzle parts to be swapped without shutting down the whole tundish, lowering casting downtime for steel mill. Changtai has supplied this modular nozzle system for many domestic and overseas steel‑making projects, with mature CNC, CNM and MNC series products for different caster requirements.
The assembly consists of refractory consumables plus mechanical fastening parts. Its key components are listed below.
Upper Tundish Nozzle
Fixed onto tundish bottom and not replaced during casting cycles. It is built with zirconia insert embedded in high‑alumina castable or pressed refractory body, providing long‑term service life. Flat contact surface is precisely machined to guarantee tight fit with sliding components, avoiding steel leakage at joint gaps.
Sliding Gate Plate Set
Includes fixed plate and sliding plate. Driven by external hydraulic or manual mechanism, the sliding plate moves horizontally to open, throttle or shut off molten steel flow. During nozzle replacement, this set cuts steel stream to enable safe part swap. Surface flatness is strictly controlled to resist high‑temperature erosion.
Quick‑Change Lower Nozzle
The replaceable refractory piece below gate plates. Equipped with metal outer shell, it can be detached and installed on‑line. Its inner zirconia insert bears direct scouring from molten steel. Changtai offers both cast and pressed‑formed versions, with typical service life ranging 10‑15 heats subject to steel grade and operating conditions.
Submerged Entry Nozzle (SEN)
Connected beneath lower nozzle. It submerges into mould molten steel bath, isolating liquid steel from air so as to reduce secondary oxidation and slag entrapment. Flow channel and outlet geometry are customised according to billet types.
Quick‑Clamping Hardware Brackets, springs and locking fixtures. These mechanical parts keep refractory layers pressed together during casting. Sustained compression helps to maintain sealing performance under thermal cycling.
Refractory Sealing Pads / Gaskets
Placed between every mating refractory faces. They fill minor surface gaps, block air ingress and prevent penetration of molten steel. Proper gasket selection reduces risk of steel breakout at joints.
Metal Protective Jacket
Outer steel housing for main nozzle refractories. It offers mechanical protection during handling and high‑temperature service, improves overall assembly rigidity.
For real‑site operation, steel plants can select matching component combinations. Changtai provides dimension customisation and material adjustment to fit existing caster installation interfaces.






