Molten Steel Flow Control Optimized by Exchange Tundish Nozzle

Oct 24, 2026

Ordinary tundish metering nozzles have a common problem. As casting goes on, the zirconia inner hole gets worn by hot molten steel. The hole becomes bigger, more steel flows out, and casting speed goes out of control. Once wear gets too bad, workers have to stop the caster and change the nozzle. This causes unstable steel flow and more defective billets.

The exchange tundish nozzle system fixes this problem and helps keep molten steel flow steady for long-time casting. It is made in two parts. The upper nozzle is fixed inside the tundish. The lower metering nozzle with precision zirconia core can be taken out and replaced. With mechanical or hydraulic change tools, workers can swap the worn lower nozzle while casting keeps running.

 

How it improves molten steel flow control

Keep the right hole size during the whole tundish run A new exchange nozzle insert keeps the original bore size. When the old one wears and flow changes, workers fit a new one online. Molten steel flow and casting speed go back to the target value right away, no need to stop the strand.

Cut flow changes caused by worn nozzles For standard metering nozzles, flow slowly rises as the hole erodes. The exchange nozzle avoids this slow shift. The liquid steel level in the mould stays calm. Less slag mixes into steel, and billet surface defects drop.

Switch flow rate easily for different production plans Workshops can stock exchange nozzles with different inner diameters. If they change steel grade or need a different casting speed, they can fit another size nozzle without emptying the tundish. This works well for mixed production.

No big disturbance to tundish pressure The exchange process is fast. The steel level inside the tundish does not drop, so the pressure pushing molten steel stays stable. The steel flow inside tundish and mould will not be upset.

 

Main benefits for steel plants

  • Tundish service life no longer limited by nozzle wear
  • Less casting speed variation, more consistent steel quality
  • Fewer stops, less waste steel
  • Supports multi-heat continuous casting for high-output lines
  • Change one strand at a time; other strands keep working normally

 

Important point

The exchange tundish nozzle still follows the orifice flow rule, same as normal metering nozzles. It cannot adjust flow freely like stopper rods or sliding gates. Its strength is to recover the designed flow quickly after nozzle wear. It keeps the simple metering structure and adds online hot change function.

This solution suits high-volume continuous casting workshops. It is widely used for medium carbon steel, special steel and long-sequence casting.

 

Send us your strand size, target casting speed and steel grade. We supply complete exchange tundish nozzle sets and on-site technical support.

Contact now