Can Zirconia Slide Plate work for long sequence casting?
Oct 27, 2026
zirconia slide plates are built for long sequence continuous casting. Many steel mills switch to this grade when ordinary alumina-carbon plates cannot hold up for multiple heats in one casting run.
In long sequence casting, the slide plate keeps sliding under constant high temperature. Molten steel and slag wash the flow hole nonstop. Standard alumina-carbon plates wear fast. The sealing surface gets uneven easily. This causes unstable steel flow, slag sticking and early plate replacement, which breaks the casting sequence.
Changtai's zirconia slide plates use stabilized zirconia insert at the bore area. The zirconia part resists erosion and slag attack much better. The sliding face stays flat through the whole casting cycle. It reduces flow fluctuation and lowers the risk of steel leakage in long sequences.
It does not mean every zirconia plate fits all long sequence jobs. The stabilizer formula, density and production process make a big difference. Poor stabilized zirconia may crack from repeated thermal shock, even if zirconia content is high. Changtai matches material formula based on your steel type, slag condition and target sequence length, for carbon steel, alloy steel and stainless steel long casting lines.
Good operation still matters. Follow the preheating curve to avoid thermal crack. Keep proper gate pressure and check the fit of sealing faces. Even good zirconia plates will fail if installation and preheating are wrong.
The upfront cost of zirconia slide plates is higher than alumina-carbon options. But for long sequence production, fewer ladle changes and less unplanned shutdown bring down total refractory cost. It also helps stabilize steel quality and cut inclusion defects.
If your plant plans longer casting sequences, Changtai can provide zirconia slide plates and technical support. Send us your steel grade, ladle size and expected heats per sequence, we will recommend the right specification.






